Creating Datum Targets

<< Click to Display Table of Contents >>

Navigation:  Solidworks General Information > Creating GD&T in Solidworks >

Creating Datum Targets

1.To insert a datum target go to Insert arrowDCS Annotations arrowDCS Datum Target

2.Select the surface, slot, hole, etc. to place the datum target and then left click again to set the datum target position in the model

3.In the PropertyManager on the left hand side, the Style, Settings, and Leader can be chosen and changed for the datum target

 

Creating Datum Targets 1

 

4.Once finished click the green check mark to save the changes made

 

Creating Datum Targets 2