Creating Views

<< Click to Display Table of Contents >>

Navigation:  NX General Information > Adding GD&T in NX >

Creating Views

Creating Views in NX is the first step to creating PMI. The views are where the PMI will be located.

 

 

Procedure:

1.Open a part to create PMI.

2.Click Part Navigator Part Navigator in the left hand vertical toolbar.

3.Click the [+] next to Model Views to open up the model views.

4.Right Click on a view and select [Make Work View] to apply PMI just in that view. PMI can also be applied in the Trimetric, Isometric, or Dimetric views.

Model Views


 

Setting Views for Assembly view (NX 9-12 shown):

1.Make sure the Parts are fully loaded

2.While in the assembly, go to the Part Navigator.

3.Right-click on the PMI Assembly Filter -> Add Filter -> select Display All.

NX_Add Filter

4.Right-click on the new filter and select Add to Views…

NX_Apply Filters to Views

5.Select from the list of Views to apply the filter.

NX_Filter Views list