Lesson1 Review the Start Model

<< Click to Display Table of Contents >>

Navigation:  Tutorials > Gear Modeling Tutorial >

Lesson1 Review the Start Model

Open the Lesson1_Start Model from C:\Users\Public\Public Documents\DCS\3DCS_All Platforms_8_0_0_1\Tutorials

to review and understand the start up Model.

 

The Model have 3 Gears and 3 Bearings which need to be assembled to its Nominal Position and also Toleranced before we get into the Gear Modeler to calculate all the Gear based output Measurements. In this lesson we will go through this as we review the completed Model which have the Points, Moves and GD&Ts.

 

clip0152

 

 

Gear Points

Expand the point list of each Gear which has three points: CntPt1, CntPt2 and ClockPt which we will be using it in the Gear Modeler.

       

         

 

clip0156

 

 

 

 

 

 

Moves

All the Gears are build to their Bearings using Feature Moves.

The assembly has 3 Feature Moves and it is grouped under the Move list.

 

clip0155

 

GD&Ts

All the Gears and Bearings are toleranced.

Under each Gear and Bearing part expand the GD&T list folder to click through the GD&Ts to see how the features are Toleranced.

clip0153

 

clip0154

 

 

 

Graphical Analysis

 

DVTI_dcsNominalBuildNominal Build the Model to see how the model gets assembled.

clip0164

 

DVTI_dcsDeviate Deviate the Model to see the Tolerance getting applied on all the parts.