<< Click to Display Table of Contents >> Navigation: »No topics above this level« Mechanical Validation |
Select the Validation icon to check if any errors are in the model. Users can also Validate their model when running a Simulation. The errors shown below are some that can affect the model Simulation and cause failed builds.
|
Mechanical Validation Status *Error will indicates that this type of error found in the run log causes a failed assembly condition
|
|||
Move Type |
Status |
Message |
Solution |
|
|||
All Joints/Constraints |
Warning |
Target Features NOT within Move Target Component |
Check if the object/target points are in the correct component. |
|
|||
|
|||
|
|||
|
|||
Contact Constraint |
Warning |
Surface is treated as Point in this Curve-Contact. |
Changes the contact-type to use a point (sphere = center point) instead of the surface. |
|
|||
|