Modifying the Model

<< Click to Display Table of Contents >>

Navigation:  Tutorials > 3DCS Variation Analyst Tutorial >

Modifying the Model

In this lesson, you will learn how you can use 3DCS to perform what-if types of engineering changes. We will be making three separate changes to your model:

 

1.Change a tolerance.

2.Change the geometry of the parts.

3.Change the way Turnlamp locate to Bracket

 

For each of these modifications, we will re-run the analysis to see how it affects the variation. In order to make an engineering decision, the following would need to be considered:

 

DecisionDiagram

 

For the baseline model, we will use the completed model from Lesson 6.