Lock the Base

<< Click to Display Table of Contents >>

Navigation:  Tutorials > 3DCS FEA Compliant Modeler Tutorials > CM Rail Training > Add Compliant Moves and Measures >

Lock the Base

VIII. Lock the Base (LockDOF_Base__B_C)

 

Purpose and usage:

LockDOF is a constraining method without part deformation. Mostly applied to constrain a point in space without the involvement of a Fixture.

It is used to constrain a hole on a pin after it was floated with a rigid move in one or two directions.

 

Things to know about LockDOF:

=> It's applied only on unconstrained flexible parts (before clamps, joins, etc).

=> Locked points do not move when subsequent compliant moves are applied.

=> This is not a permanent operation; you can release these features using the UnLockDOF move.

=> Locking applies square to grid only, in pure x, y, or z directions.

 

8.1 The B_Base hole will be locked in X-dir and Y-dir and the C_Base slot will be locked in Y-dir only. This way the hole and slot can slide on the AsmFixture pins in Z-dir.

8.1.1 Select thepos_mv_24 LockDOF icon and chose the CMRailAsm product as parent part.

8.1.2 Name the move "LockDOF_Base__B_C" with a description of "LockDOF Base hole in x, y-dir and slot width in y-dir"

8.1.3 Click on the [ClickToAdd] button in the Positioning Pts section and select points B_Base and C_Base on the Base part from the Navigation Tree or from the Graph window.

8.1.4 In the XYZ section check the X and Y boxes for B_Base to constrain it in X and Y directions.

8.1.5 In the XYZ section check the Y box for C_Base to constrain it in Y direction only. This will allow the C_Base point to slide in Y-dir, along the Fixture pin.

8.1.6 Rx, Ry, Rz are rotational degrees of freedom. Leave the rotations free.

CompMod_position_1

 

8.1.7 The completed dialog box should appear as below:

 

clip0035

 

8.1.8 Click [OK] to close the LockDOF move dialog box.

8.1.9 Save the model.

 

 

Results:

The nominal values of the measurements after locking the Base remain unchanged.