Line-Line

<< Click to Display Table of Contents >>

Navigation:  Analysis Modeling > Measures > Types of Measures > Line-Angle >

Line-Line

The DVTI_lineang Line-Line measurement is based on the relative orientation of two lines.

 

Also see:  

Vector Direction

Before Analysis Validation

After Analysis Validation

Example Model:

C:\Users\Public\Documents\DCS\3DCS_All Platforms_8_0_0_1\3DCS CAD & Example Models\Reference Models\Measures\Line to Line

 

 

Input:

Geometry Requirements: 4 Points

Measure Type: Line-Line

Direction Mode: True Angle, Projected on Plane

Direction: Required for: Projected on Plane


Output:

Direction Mode: True Angle

The measurement calculates the true angle between the two lines. The measurement will be between 0 and 180 degrees. No direction vector applies. This mode may produce incorrect Contributor Analysis or GeoFactor Equation-Based results, see Analysis Comparison & Assumptions.

 

melnln1ME

 

Direction Mode: Projected on Plane

The measurement calculates the true angle as it is viewed from the direction specified. The measurement will be between -180 and +180 degrees. The measurement will be negative if the angle between the direction vector and the two line vectors is more than 90 degrees.

 

melnln2ME