<< Click to Display Table of Contents >> Navigation:  Multi-CAD General Information > Working with Geometric Entities > Modifying Geometric Entities > Modify Holes

Procedure:

•Click on Geometry Modify Holes.

•This brings up the Click Graph window dialog box displaying Select Hole End Point.

•Go to the Graph window and click on the center point of either of the circles that define the hole needing edited.

•If there are multiple holes at this point, the dialog box Sel One will open.  Highlight the desired hole and click OK.

•This displays the hole dialog box with all the current parameters of the hole.

•Edit any parameter in the hole dialog box.

•Once the required parameters have been edited, click on OK to set the defined parameters. Cancel escapes the command.

 

Also See:   Create Holes

 Delete Entities