Sweep

<< Click to Display Table of Contents >>

Navigation:  Analysis Output > Graphical Analysis >

Sweep

The DVTI_dcsSweep Sweep function is used to graphically see the variation in a model. When the parts are DVTI_dcsSeparate_SP Separated, DVTI_dcsSweep Sweep will vary all 3DCS entities (points, features, lines, circles, and slots) according to the tolerances applied to them (size tolerances and GD&T included). When a model is DVTI_dcsNominalBuild Built, DVTI_dcsSweep Sweep will display each build variation by varying the 3DCS entities of the individual parts and assembling them together according to the active Moves.

 

Sweep will leave behind a trace of each assembly build.

 

 

The parts will start deviating according to the variation in the model. Use the Hold button to pause the deviations, and the Cancel button to stop the deviations.

 

DeviateControlContDCS

 

The Run At box displays the current number of the assembly deviation being performed. The default total steps number is 100000. The Delay drop-down number box lets you select delay times from 0 - 25000 in different increments. The higher the number, the slower the deviation.