<< Click to Display Table of Contents >> Navigation: Analysis Modeling > Tolerances > 3DCS Tolerances > Types of Tolerances |
The different types of tolerances available in 3DCS are listed below and outlined in greater detail in the following pages.
|
Tolerance Type |
Description |
---|---|
A tolerance function to create Profile, Composite Profile, Flatness and other form type tolerances. |
|
A tolerance function to create Position, Composite Position, and other orientation or location type tolerances. |
|
A size-type tolerance to create size variation on a point or a group of points. |
|
A tolerance function to create other GD&T type tolerances, non-GD&T type tolerances, or to use external data from QDM or Plant Data as tolerance variation. |
|
A tolerance to simulate a point following along the path of an arc. |
|
A tolerance function to define two different directions. |
|
A tolerance function to define three different directions. |
|
A tolerance function that may be applied to any straight feature of size, with a common axis and circular cross sections: hole, pin, shaft, etc. |