Simulation-Based Sensitivity

•The (PLTZF) information is added to the top call-out of the composite tolerance in the SBS. (73116)

Validate

•Warning added for Datum Optimizer: "Considering the excess of optimizations over full-factorial simulations, it's advisable to utilize the latter to ensure finding the global optimum. Cancel the optimization?" (72769)

Dialog

•Fixed the GeoFactor Analyzer dialog to display the Data Set display correctly, after Closing and Re-opening. (74417)

•The loaded *.dop file name and path are displayed in the Datum Optimizer.(73659)

Animation Accelorator

•Added Color Contour support for LSA. (73499)

No changes were made for 3DCS Advanced Analyzer and Optimizer for 8.0.0.1.

General

•The auto-refinement contributors can be selected in GeoFactor Matrix. (72724)

•Fixed an issue when changing the Sigma numbers in Contributor Analysis to also apply it in all AAO dialogs. (71853)        

•The composite tolerance with custom direction is showing the correct factors and contribution to variation in SBS.(71682)

•Geo Factor value for composite tolerance PLTZF callout in SBS, is now correct.(72117)

Datum Optimizer

•Running Datum Optimizer with a large number of primary candidates, when the number of fixed candidates equals the number of primary datums (resulting in one simulation), runs as expected when using Full Factorial; the calculation does not take a long time anymore. (72776)

•The minimum optimization default number is now set to 160000 when the Full Factorial number exceeds 1000000. (73072)

•Candidates and Constraints remembers the 'Locked' preferences at dialog closing. (72630)

•Added protection to prevent the user from setting the Number of Primary Datums to be smaller than the Fixed Candidates.(72768)

•The Optimized Datums for CM models are displayed in the correct columns for primary, secondary, tertiary.(72467)

•Will display the model's units for its results. (72661)

•The output file has been reformatted to display the datums in separate columns in Excel. (71698)

•Candidates and Constraints can now be selected more than one at the time using the Ctrl and Shift commands. (72629)

•Candidates and Constraints does not scroll to the top anymore when checking the 'Locked' box. (72620)

• Added a warning message to Datum Optimizer: "The number of simulations exceeds the limitation (1,000,000), please consider reducing the combination."(72607)

Dialogs

•The percent columns in CTI will now display the correct value when the model is set to a different unit than mm, and the filter will work as expected. (70701)

•The point selection from other parts in Datum Optimizer is now blocked. (72214)

•The GeoFactor Matrix will now display the selected measure or contributor in the graphics window.

•Removed the Show Tolerance and Show Measure buttons. (70349)

No changes were made for 3DCS Advanced Analyzer and Optimizer for 7.10.0.0.

No changes were made for 3DCS Advanced Analyzer and Optimizer for 7.9.0.2.

Datum Optimizer

•Results in Datum Optimizer are consistent when optimizing with fixed or not fixed candidates.(71111)

Datum Optimizer

•Datum Opt calculation is improved for flat parts to match the LockDOF/Soft Clamp results. (69680)

•Datum Opt now detects the mass matrix if it's already loaded with Load FEA move. (69602)

Sequence Optimizer

•The Join or Clamp operations can be selected at the sub assembly level as well in the Sequence Optimizer. (69505)

•The user is prompted to NB when clicking Run Evaluations if the model is not built. (69524)

•Sequence Optimizer is enhanced with the new user-defined joining order option. (68843)