<< Click to Display Table of Contents >> Navigation: Analysis Modeling > Tolerances > GD&T > Types of GD&Ts |
3DCS contains all GD&T options available per the ASME Y14.5.2 Standard published in 2009. Analytically the GD&T does not always perfectly match the allowable variation per the Standard. Each of these pages are meant to describe how 3DCS treats the callouts.
|
GD&T Types |
Descriptions |
---|---|
Apply a size tolerance to a Feature of Size such as a hole, pin, slot, tab, etc. |
|
Apply a Position GD&T to a feature. This varies the location of the feature. |
|
Apply a Surface Profile GD&T to a surface. This typically varies the location of the feature. |
|
Apply a Flatness GD&T to a planar surface. This varies the form of the feature. |
|
Apply a Perpendicularity GD&T to a planar surface or Feature of Size. This varies the orientation of the feature. |
|
Apply an Angularity GD&T to a planar surface or Feature of Size. This varies the orientation of the feature. |
|
Apply a Parallelism GD&T to a planar surface or Feature of Size. This varies the orientation of the feature. |
|
Apply a Straightness GD&T to a planar surface or Feature of Size. This varies the form of the feature. |
|
Apply a Total Runout GD&T to a planar surface or cylindrical Feature of Size. This varies the location of the feature. |
|
Apply a Circular Runout GD&T to a planar surface or Feature of Size. This varies the location of the feature. |
|
Apply a Circularity GD&T to an axial Feature of Size. This varies the form of the feature. |
|
Apply a Circularity GD&T to a cylindrical Feature of Size. This varies the form of the feature. |
|
Apply a Concentricity GD&T to a cylindrical Feature of Size. This varies the location of the feature. |
|
Apply a Symmetry GD&T to a slot or tab Feature of Size. This varies the location of the feature. |
|
Apple a Line Profile GD&T to a planar surface or Feature of Size. This varies the location of the feature. |
|
Apply a Dimensioning Location GD&T to a pair of features. This varies the location of the feature and is meant to be used for drawings that primarily use linear dimension tolerancing rather than GD&T. |
|
Apply an Angle Size GD&T to a pair of features. This varies the location and orientation of a feature and is meant to be used for any angle tolerances on the drawing that are meant to add a location to a feature. |
|
Apply a Torus Minor Diameter Size GD&T to a torus type Feature of Size. |
Special GD&T functions: